Prescription Drug Information: Intralipid

INTRALIPID — soybean oil emulsion
Fresenius Kabi USA, LLC

1 INDICATIONS AND USAGE

Intralipid® is indicated as a source of calories and essential fatty acids for adult and pediatric patients requiring parenteral nutrition (PN) and as a source of essential fatty acids for prevention of essential fatty acid deficiency (EFAD).

2 DOSAGE AND ADMINISTRATION

2.1 Important Administration Instructions

  • Intralipid is prepared and administered by a healthcare provider in the inpatient setting. Patients and caregivers may prepare and administer Intralipid for home use after appropriate training by a trained healthcare provider.
  • Intralipid is for intravenous infusion into a central or peripheral vein.
  • Do not exceed the recommended maximum infusion rate in Table 1 [see Dosage and Administration (2.3) and Warnings and Precautions (5.1)].
  • Intralipid admixtures with osmolarity
    • Greater than or equal to 900 mOsm/L must be infused through a central vein.
    • Less than 900 mOsm/L may be administered either through a central or peripheral vein.
  • Use a 1.2 micron in-line filter during administration.
  • Use a dedicated infusion line without any connections. Do not connect multiple medications in series.
  • To prevent air embolism, use a non-vented infusion set or close the vent on a vented set and fully evacuate residual gas in the bag prior to administration.
  • Do not pressurize the flexible bag to increase flow rates, and if administration is controlled by a pumping device, turn off the pump before the bag runs dry.
  • Do not use infusion sets and lines that contain di-2-ethylhexyl phthalate (DEHP), including infusion sets that contain polyvinyl chloride (PVC) components, because they contain DEHP as a plasticizer.
  • Intralipid can be infused concurrently into the same vein as dextrose-amino acid solutions (as part of PN) by a Y-connector located near the infusion site; flow rates of each solution should be controlled separately by infusion pumps.
  • After connecting the infusion set, start infusion of Intralipid immediately. Complete the infusion within 12 hours when using a Y-connector and within 24 hours when used as part of an admixture.

2.2 Preparation Instructions

Use the following instructions to prepare single-dose 100 mL, 250 mL, and 500 mL Flexible containers for administration:

Figure
1. Inspect Bag
  • Inspect the integrity indicator (Oxalert®) (A) before removing the overpouch.
  • Discard the product if the indicator is black, overpouch is opened or damaged, emulsion color is not white, or seals of bag are broken.
Figure
2. Remove Overpouch
  • Place the bag on a clean, flat surface.
  • Tear the overpouch at notch and pull down.
  • Discard the Oxalert sachet (A) and the oxygen absorber (B).
  • Visually inspect the bag and contents for particulate matter and discoloration prior to administration. The lipid emulsion should be a homogenous liquid with a milky white appearance. If the mixture is not white or the emulsion has separated (noted by discoloration, phase separation, or oily droplets), or if particulates and/or leakage are observed, discard the bag.
Figure
Figure
3. Spike Bag
  • Identify the infusion port (blue cap with the arrow pointing away from the bag).
  • Immediately before inserting the infusion set, break off the blue infusion port cap.
  • Use infusion sets according to ISO Number 8536-4 with an external spike diameter of 5.5 to 5.7 mm and use a non-vented infusion set or close the air-inlet on a vented set.
  • Use a 1.2 micron in-line filter for administration.
  • Hold the base of the infusion port.
  • Insert the spike through the infusion port by rotating your wrist slightly until the spike is inserted.
  • Do not pierce the infusion port more than once.
Figure
4. Hang the bag
  • On the hanger cut and start infusion.
  • Discard unused portion.

Intralipid 100 mL, 250 mL, and 500 mL single-dose Flexible Containers

  • After removing the overpouch, infuse immediately. If not used immediately, the product should be stored at 2°C to 8°C (36°F to 46°F) for no longer than 24 hours. After removal from storage, infuse within 12 hours when using a Y-connector and within 24 hours when used as part of an admixture.

Intralipid 1,000 mL Pharmacy Bulk Package

  • For admixing use only and not for direct intravenous infusion. Prior to administration, transfer to a separate PN container for individual patient use.
  • Transfer the contents through the blue infusion port using a suitable sterile transfer device or dispensing set. Discard any unused contents.
  • Use the Pharmacy Bulk Package immediately for admixing after removal from the overpouch. If not used immediately, the product can be stored for no longer than 24 hours at 2°C to 8°C (36°F to 46°F). After removal from storage, and once the closure is penetrated, use Pharmacy Bulk Package contents within 4 hours.

Admixing Instructions

  • Prepare the admixture in PN containers using strict aseptic techniques to avoid microbial contamination.
  • Do not add Intralipid to the PN container first; destabilization of the lipid may occur. The prime destabilizers of emulsions are excessive acidity (such as a pH <5) and inappropriate electrolyte content. Amino acid solutions exert buffering effects that protect the emulsion from destabilization. Give careful consideration to the addition of divalent cations (Ca++ and Mg++), which have been shown to cause emulsion instability.
  • Do not inject additives directly into Intralipid.
  • Intralipid may be mixed with amino acid and dextrose injections to produce “all-in-one” PN admixtures. The mixing sequence below must be followed for manual compounding to minimize pH-related problems by ensuring that typically acidic dextrose injections are not mixed with lipid emulsions alone; shake bags gently after each addition.
    • Transfer dextrose injection to the PN container.
    • Transfer amino acid injection.
    • Transfer Intralipid.
  • Simultaneous transfer of amino acid injection, dextrose injection, and Intralipid to the PN container is also permitted; follow automated compounding device instructions as indicated. Use gentle agitation during admixing to minimize localized concentration effects.
  • Additions to the PN admixtures should be evaluated by a pharmacist for compatibility. Questions about compatibility may be directed to Baxter Healthcare.
  • Inspect the admixture to ensure that precipitates have not formed during preparation of the admixture and the emulsion has not separated. Discard the admixture if any of the above are observed.
  • Infuse admixtures containing Intralipid immediately. If not used immediately, store admixtures under refrigeration at 2°C to 8°C (36°F to 46°F) for no longer than 24 hours. Infusion must be complete within 24 hours after removal from refrigeration. Discard any remaining admixture.
  • Protect the admixed PN solution from light.
Figure Figure Figure Figure Figure

2.3 Recommended Dosage and Administration

  • The recommended nutritional requirements of lipid and recommended dosages of Intralipid to be administered to meet those requirements for adults and pediatric patients are provided in Table 1, along with recommendations for the initial and maximum infusion rates.
  • The dosing of Intralipid depends on the patient’s individual energy requirements influenced by age, body weight, tolerance, clinical status, and the ability to metabolize and eliminate lipids.
  • When determining dose, energy supplied by dextrose and amino acids from PN, as well as energy from oral or enteral nutrition, has to be taken into account. Energy and lipid provided from lipid-based medications should also be taken into account (e.g., propofol).
  • Prior to administration of Intralipid, correct severe fluid and electrolyte disorders and measure serum triglyceride levels to establish a baseline value. In patients with elevated triglyceride levels, initiate Intralipid at a lower dosage and titrate in smaller increments, monitoring the triglyceride levels with each adjustment [see Warnings and Precautions (5.7)].
Table 1: Recommended Pediatric and Adult Dosage and Infusion Rate

* The neonatal period is defined as including term, post-term, and preterm neonates. The neonatal period for term and post-term neonates is the day of birth plus 27 days. For preterm neonates, the neonatal period is defined as the day of birth through the expected age of delivery plus 27 days (i.e., 44 weeks post-menstrual age).

** Daily dosage should also not exceed a maximum of 60% of total energy requirements [see Overdosage (10)].

Age Nutritional Requirements Direct Infusion Rate
Recommended Initial Dosage and Maximum Dosage Initial Maximum
Birth to 2 years of age (including preterm and term neonates*)[see Warnings and Precautions (5.1)] Initial 0.5 g/kg/daynot to exceed 3 g/kg/day** 0.1 mL/kg/hour for the first 10 to 15 minutes; gradually increase to the required rate after 15 minutes 0.75 mL/kg/hour
Pediatric patients2 to <12 years of age Initial 1 to 2 g/kg/daynot to exceed 2.5 g/kg/day*** 0.2 to 0.4 mL/kg/hour for the first 10 to 15 minutes; gradually increase to the required rate after 15 minutes 0.75 mL/kg/hour
Pediatric patients 12 to 17 years of age Initial 1 g/kg/daynot to exceed 2 g/kg/day** 0.2 mL/kg/hour for the first 10 to 15 minutes; gradually increase to the required rate after 15 minutes 0.75 mL/kg/hour
Adults 1 g/kg/day in stable patients≤1 g/kg/day in critically ill patientsnot to exceed 2.5 g/kg/day; not more than 500 mL of Intralipid should be infused on the first day of therapy** 0.2 mL/kg/hour for the first 10 to 15 minutes; gradually increase to the required rate after 30 minutes 0.5 mL/kg/hour

Dosage Modifications in Patients with Essential Fatty Acid Deficiency

When Intralipid is administered to correct essential fatty acid deficiency (EFAD), supply 8% to 10% of caloric input from Intralipid in order to provide adequate amounts of linoleic and linolenic acids.

RxDrugLabels.com provides trustworthy package insert and label information about marketed prescription drugs as submitted by manufacturers to the U.S. Food and Drug Administration. Package information is not reviewed or updated separately by RxDrugLabels.com. Every individual prescription drug label and package insert entry contains a unique identifier which can be used to secure further details directly from the U.S. National Institutes of Health and/or the FDA.

As a leading independent provider of trustworthy medication information, we source our database directly from the FDA's central repository of drug labels and package inserts under the Structured Product Labeling standard. RxDrugLabels.com provides the full prescription-only subset of the FDA's repository. Medication information provided here is not intended as a substitute for direct consultation with a qualified health professional.

Terms of Use | Copyright © 2024. All Rights Reserved.