Prescription Drug Information: Sterile Water

STERILE WATER- water injection
Hospira, Inc.

Glass Vial Plastic Vial

DESCRIPTION

This preparation is designed solely for parenteral use only after addition of drugs that require dilution or must be dissolved in an aqueous vehicle prior to injection.

Sterile Water for Injection, USP is a sterile, nonpyrogenic preparation of water for injection which contains no bacteriostat, antimicrobial agent or added buffer and is supplied only in single-dose containers to dilute or dissolve drugs for injection. For I.V. injection, add sufficient solute to make an approximately isotonic solution.

Water for Injection, USP is chemically designated H2 O.

The glass vial is Type I or II borosilicate glass and meets the requirements of the powdered glass test according to the USP standards.

The semi-rigid vial is fabricated from a specially formulated polyolefin. It is a copolymer of ethylene and propylene. The safety of the plastic has been confirmed by tests in animals according to USP biological standards for plastic containers. The container requires no vapor barrier to maintain the proper labeled volume.

CLINICAL PHARMACOLOGY

Water is an essential constituent of all body tissues and accounts for approximately 70% of total body weight. Average normal adult daily requirement ranges from two to three liters (1.0 to 1.5 liters each for insensible water loss by perspiration and urine production).

Water balance is maintained by various regulatory mechanisms. Water for distribution depends primarily on the concentration of electrolytes in the body compartments and sodium (Na+) plays a major role in maintaining physiologic equilibrium.

The small volume of fluid provided by Sterile Water for Injection, USP when used only as a pharmaceutic aid for diluting or dissolving drugs for parenteral injection, is unlikely to exert a significant effect on fluid balance except possibly in neonates or very small infants.

INDICATIONS AND USAGE

This parenteral preparation is indicated only for diluting or dissolving drugs for intravenous, intramuscular or subcutaneous injection, according to instructions of the manufacturer of the drug to be administered.

CONTRAINDICATIONS

Sterile Water for Injection, USP must be made approximately isotonic prior to use.

WARNINGS

Intravenous administration of Sterile Water for Injection without a solute may result in hemolysis.

PRECAUTIONS

Do not use for intravenous injection unless the osmolar concentration of additives results in an approximate isotonic admixture.

Consult the manufacturer’s instructions for choice of vehicle, appropriate dilution or volume for dissolving the drugs to be injected, including the route and rate of injection.

Inspect reconstituted (diluted or dissolved) drugs for clarity (if soluble) and freedom from unexpected precipitation or discoloration prior to administration.

Pregnancy: Animal reproduction studies have not been conducted with Sterile Water for Injection. It is also not known whether sterile water containing additives can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Sterile Water for Injection with additives should be given to a pregnant woman only if clearly needed.

Pediatric Use

Safety and effectiveness have been established in pediatric patients. However, in neonates or very small infants the volume of fluid may affect fluid and electrolyte balance.

Drug Interactions

Some drugs for injection may be incompatible in a given vehicle, or when combined in the same vehicle or in a vehicle containing benzyl alcohol. Consult with pharmacist, if available.

Use aseptic technique for single or multiple entry and withdrawal from all containers.

When diluting or dissolving drugs, mix thoroughly and use promptly.

Do not store reconstituted solutions of drugs for injection unless otherwise directed by the manufacturer of the solute.

Do not use unless the solution is clear and seal intact. Do not reuse single-dose containers. Discard unused portion.

ADVERSE REACTIONS

Reactions which may occur because of this solution, added drugs or the technique of reconstitution or administration include febrile response, local tenderness, abscess, tissue necrosis or infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection and extravasation.

If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate countermeasures, and if possible, retrieve and save the remainder of the unused vehicle for examination.

OVERDOSAGE

Use only as a diluent or solvent. This parenteral preparation is unlikely to pose a threat of fluid overload except possibly in neonates or very small infants. In the event these should occur, re-evaluate the patient and institute appropriate corrective measures. See WARNINGS, PRECAUTIONS and ADVERSE REACTIONS.

DOSAGE AND ADMINISTRATION

The volume of the preparation to be used for diluting or dissolving any drug for injection is dependent on the vehicle concentration, dose and route of administration as recommended by the manufacturer.

This parenteral should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

HOW SUPPLIED

Sterile Water for Injection, USP is supplied in the following:

Unit of Sale Total Content

NDC 0409-4887-05 Tray of 25 Single-dose Glass Fliptop Vials

1 mL

NDC 0409-4887-10 Tray of 25 Single-dose Plastic Fliptop Vials

10 mL

NDC 0409-4887-34 Tray of 30 Single-dose Plastic Fliptop Vials

10 mL

NDC 0409-4887-20 Tray of 25 Single-dose Plastic Fliptop Vials

20 mL

NDC 0409-4887-50 Tray of 25 Single-dose Plastic Fliptop Vials

50 mL

NDC 0409-4887-99 Case of 25 Single-dose Glass Fliptop Vials

100 mL

Store at 20 to 25°C (68 to 77°F). [See USP Controlled Room Temperature.]

Distributed by Hospira, Inc., Lake Forest, IL 60045 USA

Hospira logo

LAB-1292-2.0

Revised: 05/2021

PRINCIPAL DISPLAY PANEL — 100 mL Vial Label

100 mL
Single-dose

WARNINGS: NOT ISOTONIC. HEMOLYTIC.

Sterile Water
For Inj., USP

FOR DRUG DILUENT USE ONLY

Distributed by Hospira, Inc., Lake Forest, IL 60045 USA

LOT ##-###-AAEXP DMMMYYYY

PRINCIPAL DISPLAY PANEL -- 100 mL Vial Label
(click image for full-size original)

PRINCIPAL DISPLAY PANEL — 1 mL Vial Label

1 mL Fill Single-dose

Sterile Water
for Injection,USP

Rx only

Hospira

Hospira, Inc., Lake Forest, IL 60045 USA

PRINCIPAL DISPLAY PANEL -- 1 mL Vial Label
(click image for full-size original)

PRINCIPAL DISPLAY PANEL — 10 mL Vial Label — NDC 0409-4887-17

10 mL Single-dose

Sterile Water
for Injection, USP

FOR DRUG DILUENT USE

LOT ##-###-AAEXP DMMMYYYY

PRINCIPAL DISPLAY PANEL -- 10 mL Vial Label -- NDC 0409-4887-17
(click image for full-size original)

PRINCIPAL DISPLAY PANEL — 10 mL Vial Tray — NDC 0409-4887-10

10 mL Single-dose

Rx only
NDC 0409-4887-10Contains 25 of NDC 0409-4887-17

Sterile Water for Injection, USP

FOR DRUG DILUENT USE

Hospira

PRINCIPAL DISPLAY PANEL -- 10 mL Vial Tray -- NDC 0409-4887-10
(click image for full-size original)

PRINCIPAL DISPLAY PANEL — 10 mL Vial Label — NDC 0409-4887-32

10 mL Single-dose

Sterile Water
for Inj., USP

Rx only

Hospira

LOT ##-###-AAEXP DMMMYYYY

PRINCIPAL DISPLAY PANEL -- 10 mL Vial Label -- NDC 0409-4887-32
(click image for full-size original)

PRINCIPAL DISPLAY PANEL — 10 mL Vial Tray — NDC 0409-4887-34

10 mL Single-dose

Rx only

NDC 0409-4887-34Contains 30 of NDC 0409-4887-32

Sterile Water for Injection, USP

FOR DRUG DILUENT USE

Hospira

PRINCIPAL DISPLAY PANEL -- 10 mL Vial Tray -- NDC 0409-4887-34
(click image for full-size original)
Page 1 of 2 1 2

RxDrugLabels.com provides trustworthy package insert and label information about marketed prescription drugs as submitted by manufacturers to the U.S. Food and Drug Administration. Package information is not reviewed or updated separately by RxDrugLabels.com. Every individual prescription drug label and package insert entry contains a unique identifier which can be used to secure further details directly from the U.S. National Institutes of Health and/or the FDA.

As a leading independent provider of trustworthy medication information, we source our database directly from the FDA's central repository of drug labels and package inserts under the Structured Product Labeling standard. RxDrugLabels.com provides the full prescription-only subset of the FDA's repository. Medication information provided here is not intended as a substitute for direct consultation with a qualified health professional.

Terms of Use | Copyright © 2024. All Rights Reserved.